Conventional scuba weight-belt with quick-release buckle | |
Other names |
|
---|---|
Uses | Buoyancy correction and trim adjustment of underwater divers |
Related items | Buoyancy compensation device |
A diving weighting system is ballast weight added to a diver or diving equipment to counteract excess buoyancy. They may be used by divers or on equipment such as diving bells, submersibles or camera housings.
Divers wear diver weighting systems, weight belts or weights to counteract the buoyancy of other diving equipment, such as diving suits and aluminium diving cylinders, and buoyancy of the diver. The scuba diver must be weighted sufficiently to be slightly negatively buoyant at the end of the dive when most of the breathing gas has been used, and needs to maintain neutral buoyancy at safety or obligatory decompression stops. During the dive, buoyancy is controlled by adjusting the volume of air in the buoyancy compensation device (BCD) and, if worn, the dry suit, in order to achieve negative, neutral, or positive buoyancy as needed. The amount of weight required is determined by the maximum overall positive buoyancy of the fully equipped but unweighted diver anticipated during the dive, with an empty buoyancy compensator and normally inflated dry suit. This depends on the diver's mass and body composition, buoyancy of other diving gear worn (especially the diving suit), water salinity, weight of breathing gas consumed, and water temperature. It normally is in the range of 2 kilograms (4.4 lb) to 15 kilograms (33 lb). The weights can be distributed to trim the diver to suit the purpose of the dive.
Surface-supplied divers may be more heavily weighted to facilitate underwater work, and may be unable to achieve neutral buoyancy, and rely on the diving stage, bell, umbilical, lifeline, shotline or jackstay for returning to the surface.
Free divers may also use weights to counteract buoyancy of a wetsuit. However, they are more likely to weight for neutral buoyancy at a specific depth, and their weighting must take into account not only the compression of the suit with depth, but also the compression of the air in their lungs, and the consequent loss of buoyancy. As they have no decompression obligation, they do not have to be neutrally buoyant near the surface at the end of a dive.
If the weights have a method of quick release, they can provide a useful rescue mechanism: they can be dropped in an emergency to provide an instant increase in buoyancy which should return the diver to the surface. Dropping weights increases the risk of barotrauma and decompression sickness due to the possibility of an uncontrollable ascent to the surface. This risk can only be justified when the emergency is life-threatening or the risk of decompression sickness is small, as is the case in free diving and scuba diving when the dive is well short of the no-decompression limit for the depth. Often divers take great care to ensure the weights are not dropped accidentally, and heavily weighted divers may arrange their weights so subsets of the total weight can be dropped individually, allowing for a somewhat more controlled emergency ascent.
The weights are generally made of lead because of its high density, reasonably low cost, ease of casting into suitable shapes, and resistance to corrosion. The lead can be cast in blocks, cast shapes with slots for straps, or shaped as pellets known as "shot" and carried in bags. There is some concern that lead diving weights may constitute a toxic hazard to users and environment, but little evidence of significant risk.
© MMXXIII Rich X Search. We shall prevail. All rights reserved. Rich X Search