Rocky Mountain Trench

Rocky Mountain Trench
Rocky Mountain Trench
	Kinbasket Lake lies in the Rocky Mountain Trench
Floor elevation	600–900 m (2,000–3,000 ft)
Length	1,600 km (1,000 mi)
Width	3–16 km (2–10 mi)
Geography
Coordinates	54°30′N 122°30′W / 54.5°N 122.5°W

The Rocky Mountain Trench, also known as the Valley of a Thousand Peaks or simply the Trench, is a large valley on the western side of the northern part of North America's Rocky Mountains. The Trench is both visually and cartographically a striking physiographic feature extending approximately 1,600 km (1,000 mi) from Flathead Lake, Montana, to the Liard River, just south of the British Columbia–Yukon border near Watson Lake, Yukon. The trench bottom is 3–16 km (1.9–9.9 mi) wide and is 600–900 m (2,000–3,000 ft) above sea level. The general orientation of the Trench is an almost straight 150/330° geographic north vector and has become convenient as a visual guide for aviators heading north or south.

Although some of its topography has been carved into U-shaped glacial valleys, it is primarily a byproduct of geologic faulting. The Trench separates the Rocky Mountains on its east from the Columbia Mountains and the Cassiar Mountains on its west. It also skirts part of the McGregor Plateau area of the Nechako Plateau sub-area of the Interior Plateau of British Columbia. It is up to 25 km (16 mi) wide, if measured peak-to-peak, and varies in valley relief, but is clearly visible by air and satellite/remote sensing and is easily discernible to those ascending any of the mountains or ridges lining it.

The Trench is drained by four major river basins: the Columbia, Fraser, Peace and Liard. Two reservoirs of the Columbia River Treaty fill much of its length today - Lake Koocanusa and Lake Kinbasket. A further British Columbia power initiative created Lake Williston. Rivers that follow the Trench, at least in part, are the Kootenay River, the Columbia River, the Canoe River, the Flathead River, the Fraser River, the Parsnip River, the Finlay River, the Fox River, and the Kechika River. The North Fork of the Flathead River, flowing into Flathead Lake with the other branches of the Flathead River, is part of the Columbia River system. The Kechika is part of the Liard River system, and the Fox, Parsnip and Finlay Rivers are part of the Peace River system. The Canoe River is a short tributary of the Columbia system, draining into Kinbasket Lake, a reservoir on the Columbia River. The Kootenai River, however, does not fully follow the Trench but exits Canada southwest via Lake Koocanusa reservoir to the Libby Dam. The Kootenay River (Canadian spelling) is a tributary of the Columbia, joining the Columbia at Castlegar, BC after a meander through the United States as the Kootenai River (US spelling).

For convenience the Rocky Mountain Trench may be divided into two sections, the Northern Trench (between the Muskwa Ranges and Interior Mountains) and the Southern Trench (between the Continental Ranges and Columbia Mountains), separated by the northeastern portion of the Interior Plateau west of the Hart Ranges. The Copley Range of the Arctic Pacific Lakes Provincial Park forms the drainage divide between the northerly Parsnip-Finlay-Peace system into the Arctic Ocean (via the Mackenzie River) and the southwesterly McGregor-Fraser system into the Pacific Ocean. The northern end of the Columbia Mountains at ~54°N near Prince George, British Columbia, where the Fraser River leaves the Trench to enter the Interior Plateau, may be used for this purpose. The northern portion of the Trench is dominated by strike-slip faulting, while the southern part of the Trench was created by normal faults. Despite differences in timing and faulting styles of the northern and southern portions, they were aligned with each other because faulting for both was controlled by a pre-existing, west-facing, deep basement ramp with over 10 km (33,000 ft) of vertical offset.